The logic boiler consists of the solar boiler, the fossil fuel boiler and thermal storage as shown in
The values 114 V3, 113 V4, and 112 V5 are linear valves with redundancy that they can response to the command from the boiler controller to control the water flow rate, resulting control the water levels in the boilers.
The outputs of the boilers are connected steam mixer through valves 110 V9, and 108 V7. 110 V9, 108 V7, and 107 V8 are on and off valves with redundancy for boilers to be online or offline from the system.
The values 108 V7 and 115 V2 are thermal charge values with redundancy. They are will be “on” when the thermal storage is on charge mode, and will be “off” when the thermal storage is on discharge mode.
117 P2 adds pressure after the steam stored its energy in the thermal storage and condenses into water format.
The mixer mixes the steam from the boilers following the commands of the boiler controller. The detail structure of the mixer is illustrated by
Within the logic boiler controller, there are four models; they are 206 and 207 solar tower boiler controller, 208 and 209 fossil fuel boiler controller, 210 and 211 thermal storage controller, and 212 and 213 logic level controller.
The 206 and 207 solar tower boiler controller controls concentrate mirrors and detail operation of the receivers.
The 208 and 209 fossil fuel boiler controls the traditional fossil fuel boiler.
The 210 and 211 thermal storage controller controls the thermal storage.
The 212 and 213 logic level controller controls the detail operation of the logic boiler. It controls all values 214000 to 214nnn through and read all sensors 215000 to 215 mm. They are microprocessor based with redundancy.
Each sensor (215000 to 215 nnn) contains three sub-sensors and they are redundant to each other. Each sub-sensor has two independent outputs and connected to two redundant microprocessors. The active microprocessor will receive three independent readings from each sensor. Only two readings in agreement will be uses, and the third reading has to be within the critical range, otherwise the alarm will be triggered.
The controller drivers (214000 to 214 mmm) are designed to support redundancy.
Each pare of the redundant computers are controlled through the inter reset logic unit are illustrated in
There are three operation modes: solar boiler with thermal storage; solar boiler with fossil fuel boiler; and thermal storage with fossil fuel boiler.
When the solar boiler works with thermal storage, it contains two operational states: thermal storage charge state and thermal storage discharge state.
During the thermal storage charge state, the excessive thermal energy will send to thermal storage through valve 108 V7. The steam will deposit its energy and be condensed becoming water through 118 the thermal energy exchange with the storage material. The condensed water will be pumped by 117 P2 and send back to boilers.
During the thermal storage discharge state, the steam from the solar boiler is with parameter to maximize the solar receiving efficiency. Since the solar energy is not a stable source, the output of the thermal storage will be adjusted to compensate the steam parameter from solar boiler and the needs of the turbine.
When the solar boiler is working with 119 fossil fuel boiler, the operation is relative simple. The output of the fossil fuel boiler will compensates the variation of the output of the solar boiler and matches the demands of the steam turbine.
When 118 the thermal storage is used to provide steam for the turbine, no need for the fossil fuel boiler to be online. But, on the other hand, with the help of the fossil fuel boiler, the total energy discharge of the thermal storage can be maximized.