Patent Application
20080069940
Frozen aerated confections include ice cream, frozen yogurt and the like. Ice cream typically contains, by weight of the composition, 2-20% fat, 6-12% non-fat milk solids which consists mostly of milk protein and lactose, 12-18% other sugars together with other minor ingredients such as stabilisers, emulsifiers, colours and flavourings. The conventional manufacturing process for frozen aerated confections consists of a number of steps: (i) mixing the ingredients, (ii) pasteurization and homogenisation, (iii) ageing the mixture to produce a mix, (iv) aerating and partially freezing the mix, (v) extrusion from the freezer, and (vi) hardening. This process is described in detail in, for example, Ice Cream, 6th Edition, chapters 6-9.
Frozen aerated confections (and mixes from which they are produced) comprise milk fat. The milk fat content is at least 2%, preferably at least 4%, more preferably at least 7%. Preferably the milk fat content is at most 20%, more preferably at most 15%, most preferably at most 12%.
The milk fat has a SAFA content (by weight of the fatty acids) of at most 60%, preferably at most 56%, more preferably at most 54%, even more preferably at most 52% and most preferably at most 50%. The lower the SAFA content, the greater the health benefit.
The milk fat has a C18:0 content (by weight of the fatty acids) of at least 10%, preferably at least 11%, more preferably at least 12%, even more preferably at least 13% and most preferably at least 14%.
Preferably the milk fat has a solid fat content at 5° C. (by weight of the fatty acids) of from 35 to 50%, more preferably from 40 to 50%.
We have found that milk fats satisfying these criteria produce good quality ice creams without requiring a lower ageing temperature or a longer time than is conventional. Thus the ageing temperature is from 0 to 6° C., preferably from 2 to 5° C. Preferably the ageing time is less than 12 hours, more preferably from 1 to 6 hours, most preferably from 1 to 4 hours. It is believed (without wishing to be limited by theory) that this is a result of the specific fatty acid composition of the milk fat, in particular a relatively high proportion of C18:0 fatty acids. Low SAFA milk fats having the required fatty acid composition can be obtained by dietary intervention, as described for example in Fearon et al, J. Sci Food Agric. 84, 497-504, 2004. Fractionation, which is an alternative route for preparing low SAFA milk fats, results in fatty acid compositions which do not satisfy these criteria. In particular, while fractionation reduces the SAFA content, it also reduces the amount of C18:0 fatty acids.
Frozen aerated confections (and mixes from which they are produced) comprise protein, preferably milk protein. Suitable sources of milk protein include milk, concentrated milk, milk powders, whey, whey powders and whey protein concentrates/isolates. In order to aid in emulsification and/or aeration during manufacture of the frozen confection it is preferable that the protein content is greater than 2% by weight. In order to prevent the texture of the confection from becoming chalky, it is also preferable that the protein content is less than 8% by weight.
Frozen aerated confections (and mixes from which they are produced) also contain sugars. The sugar is typically a mono-, di-, or oligo-saccharide or sugar alcohol for instance, sucrose, dextrose, fructose, lactose (for example from milk solids), purified lactose, lactose monohydrate, glucose syrup, invert sugar, corn syrup, fructose, erythritol arabitol, xylitol, sorbitol, glycerol, mannitol, lactitol and maltitol or mixtures thereof. In order to provide freezing point depression and contribute to the sweetness of the confection it is preferred that the sugar content is at least 5%, more preferably at least 8% and most preferably at least 10% by weight. To avoid the confection being too sweet, it is preferred that the confection comprises at most 25% sugars, more preferably at most 20% and most preferably at most 18% by weight. Preferably a blend of sugars is used; more preferably one of the sugars is sucrose.
Frozen aerated confections (and mixes from which they are produced) may comprise an emulsifier, such as mono- and di-glycerides of saturated or unsaturated fatty acids, lecithin and egg yolk. Typically the emulsifier is present at a level of 0.05 to 1% by weight.
Frozen aerated confections (and mixes from which they are produced) may also comprise a stabiliser, such as gelatine, locust bean gum, guar gum, agar, alganates, carrageenan, pectin, carboxymethyl cellulose, microcrystalline cellulose, dextran and xanthan. Preferably the stabiliser is present at a level of 0.05 to 1% by weight.
In addition the frozen aerated confections (and mixes from which they are produced) may contain flavouring and/or colouring, such as mint, vanilla, chocolate, coffee, or fruit flavours. Pieces of nut, chocolate, ginger, biscuit, fruit, fruit and the like may also be included, but it will be understood that these are not to be included when determining the fat composition and content, protein content etc. of the mix.
The frozen confection is aerated with a gas such as air. Frozen aerated confections have an overrun of more than 20%, preferably more than 50%, more preferably more than 75%. Preferably the frozen confection has an overrun of less than 200%, more preferably less than 150%, most preferably less than 120%.
The present invention will be further described in the following examples and comparative examples in which compositions demonstrating various facets of the invention were prepared. The examples are by way of illustration only, and are not to limit the invention.
Thirty-two mid-late lactation Holstein Friesian dairy cows were assigned to one of four dietary treatments supplying 0, 400, 600 and 800 g rapeseed oil (in the form of whole rapeseeds)/cow/day over an eight week period. The feed trial was conducted as described in detail in J. Sci Food Agric. 84, 497-504, 2004.
The effects of dietary treatment on milk yield and composition (in particular fatty acid composition) were determined by sampling and analysing the milk from all animals individually on a weekly basis. Following extraction of the milk fat, the fatty acid composition and solid fat contents were determined, using the methods described above.
Inclusion of rapeseed oil up to 600 g/day did not affect milk yield. At 800/g day milk yield was reduced by about 10%, but the milk fat and protein concentrations in the milk were not affected. Behavioural observation assessments supported the view that the diets were not stressful to the cows. The effect on milk fat composition was established by the second week of the trial and persisted for the remaining six weeks. A minimum of 300 litres of milk per dietary treatment was collected over four consecutive milkings during week 4, pasteurized and separated into cream (37-40% fat). The cream was blast frozen and held at −20° C. until required for ice cream production. The total SAFA content of the milk fat decreased from 64% with the control diet (0 g rapeseed oil/day) to 48% with the highest level of rapeseed oil (800 g/day) while the unsaturated fat content correspondingly increased from 36% to 52%. The amounts of SAFA, C18:0 and solid fat at 5° C. and −5° C. for each dietary treatment are shown in Table 1.
The control sample (0 g) has a solid fat content at 5° C. of 55%, whereas the low SAFA samples have solid fat contents of from 41 to 47%, i.e. below the amount conventionally considered necessary to make good ice cream. The solid fat contents of the low SAFA samples measured at −5° C. range from 53 to 57%, i.e. very similar to the solid fat content of the control sample at 5° C.
Four ice creams were prepared according to the formulation given in Table 2 using the four creams from example 1.
The ice creams were prepared as follows. Water was placed in a jacketed tank at 85° C., then all the ingredients except for the flavours were dissolved by mixing with a high shear mixer. Hot water was circulated in the jacket of the tank to maintain a temperature of 65° C. The mixture was heated using a plate heat exchanger to a temperature of 83° C. and homogenised using a the first stage of a Crepaco double stage valve homogeniser at a pressure of 140 bar. After holding the mixture at 82 to 85° C. for 12 seconds, the mixture was cooled using a tubular heat exchanger to 4° C. and aged at this temperature for 2-3 hours before adding the flavour. The mix was frozen in a continuous ice cream freezer (APV Technohoy MF75) fitted with an open dasher rotating at a speed of 370 to 400 rpm and operating with a barrel pressure in the range 1-4 bar. The ice creams were produced with a mix flow rate of between 0.6 and 0.63 litres/minute, with an overrun of 100% and an extrusion temperature of −6.3° C.
All of the mixes processed well: they could reliably be aerated to 100% overrun and were smooth and dry on extrusion. Ice creams were collected in 500 ml waxed paper cartons and then hardened in a blast freezer at −35° C. for a period of 2 hours. The hardened ice creams were then stored at −25° C. until required for sensory testing.
The ice creams were assessed by a trained sensory panel consisting of 15 panellists who had been screened and selected for their sensory acuity. The panel had been trained in describing and objectively assessing the sensory attributes of a range of ice cream products. The day before panelling the blocks were cut into equally sized portions which were placed into pots. The samples were then tempered to the serving temperature (−18° C.) for 24 hours prior to panelling. The panellists consumed samples of each product and assessed a number of attributes related to texture and flavour. The test design was balanced for serving order of the samples, and each product was assessed (blind) 3 times by each assessor. A series of data and panellist monitoring techniques were performed on the data output, and these indicated that a robust dataset had been obtained. No significant differences were found in any of the sensory attributes between the control sample (0 g) and the low SAFA samples (400, 600 and 800 g).
Ice creams were prepared using a standard butter (Meadow Foods Ltd, Marlston-cum-Lache, Chester, UK) and a commercially available low SAFA butter (Dromona Pure Butter, supplied by Dale Farm Ltd, Belfast, N. Ireland). The amounts of SAFA, C18:0 and solid fat at 5° C. and −5° C. of each butter were measured as described above and are shown in Table 3.
The low SAFA butter has a solid fat content of 46% at 5° C., i.e. below the amount conventionally considered necessary to make good ice cream. The solid fat content of the low SAFA butter measured at −5° C. is 56%, i.e. similar to the solid fat content of the standard butter at 5° C. (60%).
Ice creams were made using the standard butter and the low SAFA butter using the formulation in Table 4 and the same process as in example 2. Both of the mixes processed well: they could reliably be aerated to 100% overrun and were smooth and dry on extrusion. They were collected in 500 ml waxed paper cartons and then hardened in a blast freezer at −35° C. for a period of 2 hours. The hardened ice creams were then stored at −25° C. until required for sensory testing.
The ice creams were also assessed by the trained sensory panel as described in example 2. The standard and low SAFA ice creams were found to have very similar sensory properties, although the ice cream made with the low SAFA butter was slightly smoother in texture.
All of the ice creams of examples 2 and 3 produced according to the invention processed well and there was little difference in texture or flavour between ice cream made with standard milk fat and low SAFA milk fat. Thus, contrary to what was previously thought, good quality ice cream can be made from mixes containing low SAFA milk fat, without ageing at low temperatures or for very long times.
The various features of the embodiments of the present invention referred to in individual sections above apply, as appropriate, to other sections mutatis mutandis. Consequently features specified in one section may be combined with features specified in other sections as appropriate.
All publications mentioned in the above specification are herein incorporated by reference. Various modifications and variations of the described methods and products of the invention will be apparent to those skilled in the art without departing from the scope of the invention. Although the invention has been described in connection with specific preferred embodiments, it should be understood that the invention as claimed should not be unduly limited to such specific embodiments. Indeed, various modifications of the described modes for carrying out the invention which are apparent to those skilled in the relevant fields are intended to be within the scope of the following claims.
| Number | Date | Country | Kind |
|---|---|---|---|
| EP06120698 | Sep 2006 | EP | regional |
| EP06120700 | Sep 2006 | EP | regional |
